<aside> <img src="/icons/info-alternate_blue.svg" alt="/icons/info-alternate_blue.svg" width="40px" />

There is a video at the bottom of the page going through the process of replacing a top cap on Arrowhead

</aside>

Required Tools

1x 2.5mm Hex Driver Earlier versions may utilize a smaller 1.5 mm driver for the motors

image.png

1x Spare Top Cap

TopCap.jpg

Steps

  1. Remove the four screws holding the top cap in place. If the screws are in good condition, place them to the side for reuse.

    TopCap-Repair-1.png

    TopCap-Repair-2.png

  2. Grab your spare top cap, and a single screw. Thread the screw through the top cap into one of the four holes. Do not fully tighten it down, as this will help you align the other holes and screws.

    TopCap-Repair-3.png

  3. Mount the other three screws, waiting for them all to be threaded before tightening them all down.

TopCap-Replace-Arrowhead24.mov